FAQs
当前位置:首页 - 新闻中心 - FAQs  
   HAOHAI NEWS ___
How to Troubleshooting
2019/4/3 16:22:52

1. Leaks
If you are losing air pressure, and it isnt colder temperatures, check the boat over for leaks, starting with the valves. The best tool to find leaks is soapy water in a spray bottle. A leaking valve is rare, but if you do find a leak we can send you a replacement valve. We recommend mixing soap and water in a spray bottle. Spray around the valve. If you see bubbles forming, check your valve seating and base and be sure the valve insert is screwed tight. If you continue to have problems its probably time to order new valves. Replacement of the whole valve can be


done with a simple tool that comes with the replacement valve.
2. Finding punctures
If the boat is losing air, and all the valves are good you probably have a small puncture. Small punctures can be repaired easily and permanently. Spray around inside and outside of the hull until air bubbles mark the position of the leak. If you have no luck finding a slow leak with air bubbles, inflate the boat to maximum air pressure and try to listen to find the leak. If you can narrow the area down, return with a spray bottle to identify the source of the leak. Making small repairs. Punctures less than 1/8"in size can be repaired simply without a patch. Deflate your
boat, then clean and dry area to be repaired. Apply a small drop of glue to cover the puncture, and let dry 12 hours. If you need to get on the water sooner, let dry 30 minutes and then inflate the boat, inflating the compartment with the repair only 3/4 full. This repair might not be permanent so add a drop again at a late date to make it permanent.
3. Rips or Tears
Your Transom Boats come with a repair kit as standard equipment. If you no longer have your repair kit, you can order a new one from your dealer. Cut a piece of repair material large enough to overlap the damaged area by approximately 1/2", and round off the edges. Apply our glue to the under side of patch and around the area to be repaired. Too much glue will interfere with a proper repair. Allow adhesive to become tacky for 2-4 minutes, and then place patch on the damaged area. Use a weight to apply 3-5 lbs. of pressure for 12 hours. After patch has
dried, apply glue around the edges for a complete seal (dry 4 hours).


ADD: South of Liangzhongchang, West of Weihai Road, Shuiji Street Office, Laixi,Qingdao, China    
TEL: 86-0532-88437558    FAX: 86-0532-88437558     Mobile number: 135-7324-8766
Copyright © 2019 Qingdao Haohai Boat Co., Ltd.    E-mail:admin@haohaiboat.com
sitemap                  
WWW.HAOHAIBOATS.COM Design by: Ruifoxweb.com